Add 34 and 26, divide by 2 to get 30 and turn crank 30 degrees back toward 0 (it will land either before or after TDC) then reset wheel to 0 TDC. Repeat if needed to confirm, 6 one way, half a dozen I guess. When degree wheel is used on chain driven cog, always turn in drive direction to keep tension on chain.
Hey Hugh
ReplyDeleteI'm getting ready to do this. Are you marking the rotor where the TDC mark is on one of your stickers?
Add 34 and 26, divide by 2 to get 30 and turn crank 30 degrees back toward 0 (it will land either before or after TDC) then reset wheel to 0 TDC. Repeat if needed to confirm, 6 one way, half a dozen I guess. When degree wheel is used on chain driven cog, always turn in drive direction to keep tension on chain.
ReplyDeleteJust to clarify, the amount the stop sticks out of the old spark plug, is that the entire 1.25 " you mentioned?
ReplyDelete